Railworks America

When I load containers using the MiJack Crane on Barstow to San Bernardino route in the SB Yard the containers that are being loaded are invisible. I get the red line as it loads so the instruction is being completed but I can not see the container. If anybody else has used Rick's tutorial to load the Gtrax containers with the MiJack Crane, If you get the chance please test it to see if they are invisible to you as well.

I use those containers on the NERW route. Even repainted a set of them to NERW industries. I cloned the mijack and put everything in the artimrj\routes asset folders. The containers are in railnetwork\interactive and the crane is in railnetwork\TransferPoints\Yards\MiJack Crane. You can look see what I did. It sounds to me like your container files are not pointing to the container textures.

They use to work all the time I have done it many times and I checked the bin file to be sure and they are all where they need to be. I will have to check it out on the NERW route to see if I get the same issue there.

I just checked your bin file for the crane and it is basically the same just gtrax info instead of yours.

Also make sure that G-Trax Trains is selected in the slide out menu for either the route or the scenario using the crane.

Sometimes I think I should just stay in bed. I cannot believe I was being so dumb. (Yes I know I just opened myself up for the comments have fun) Samwolf you hit it on the head. I forgot when I did a clean install a little while ago that I did not check that off. It all works just fine now. Thank you everybody for you help.

Don't feel bad, I forgot to recheck mine after the BSB update.