Railworks America

Wanted to make a scenario for the GATX SD40-2's from roinuj to play with, so I decided to go with putting together some autoracks at the plant and then taking em to Chattanooga. Easy enough, right? Wrong.


I can couple up to the first cut of racks fine, but no matter what I do, I cannot couple to any of the others! The couplers go right through each other and the cars smack end to end. Or worse yet, everything goes flying in a massive derailment at 5 mph.

Any ideas what might be causing this? Everything looks fine on the surface (no cars inside each other or anything).

Have you tried replacing the autoracks with different cars?

Not yet. But I will.

Try checking if there are any cars that are overlapping when you placed them in the scenario. I had problems like that and I made sure all the cars couple correctly in the editor.

Might help,
Marc