Paging anyone who can help!!

[cometcatt]

I've downloaded reskins for the default double stack container car, and the problem is the inability to load the cars with containers in either scenario editor or at the container gantry. Please help me sort this out

-Cometcatt

[NDORFN]

Had the same problem for months. Haven't had time to sort it out.

[krellnut]

If you mean the containers don't show up when you load them, its because the container load files are in RailSimulator. In editor, make sure you have RailSimulator ticked in the object set filter.

[artimrj]

Which containers did you download?

[cometcatt]

I downloaded the containers from this file, bobbel66-US_Cars_EOT and the container flats from the NERW mega pack. In both cases the flat itself show up but no containers when I try to load them in editor. The NERW container cars are set to carry the default containers, the bobbe containers are set to carry JB hunt containers. Also as a note the NERW container flats will load at the container crane, where as the bobbe containers don't.

[artimrj]

For the NERW containers that I did, use the object browser and choose artimrj and put a green check in routes. If you look at the readme it tells you about this for using the containers on another route other than the NERW. They are part of the route so if you run them on the NERW they will be fine, if not you have to turn on the assets under artimrj. You also have to insytall the G-Trax Freeware Huskie containers installed and make sure they are turned on. Ten cars uses NERW container that we made for the route, and 10 cars use the G-Trax container skins and models. I do not know anything about the other container set you mentioned.

[cometcatt]

These containers are a reskin for the default double stack, not the G-trax double stack you've referred to. I do however appreciate your suggestion.

[cometcatt]

I figured out the problem with the bobbel66-US_Cars_EOT containers, so one down, and the NERW container flats I can load at the gantry crane, that being said I'll leave it at good enough.

[artimrj]

These containers are a reskin for the default double stack, not the G-trax double stack you've referred to. I do however appreciate your suggestion.

The containers are default but the load are from the G-Trax Huskies.

[cometcatt]

Ah, I see. Thank you much.

[artimrj]

Ah, I see. Thank you much.

Also so you know, there are 23 cars in there. 3 of them actually use the default containers. 10 use home made for NERW loads and 10 use the G-Trax loads. In the scenario editor they are labled as to which loads they have associated with them.