Flashing Polygons

[harryadkins]

Whenever I try to run the free roam scenario on the Montour, my screen is filled with flashing polygons. I am also experiencing missing textures with the Montour SW1200's on that same route. Any ideas?

I also experienced the same issue on the Ft. Kent to Eagle Lake and the polygons seems to be connected to the CN Widenose SD40-2. My other routes seem normal.

Harry

[Trainguy76]

Try reinstalling the route. If you cannot avoid the flashing polygons by restarting a scenario, then it is likely the route is corrupted and needs to be reinstalled.

[harryadkins]

I did try re-installing the routes. Unfortunately, this seems to be related to the locomotive and it happens with the same locos on any route. The polygons are 4-sided pyramids that point into the top center of the locomotive and radiate out. They rotate and increase until you can't see the loco for the polygons. I vaguely remember a post about a similar problem months ago, but cannot find it. It all started when I installed the Montour route and its assets but I don't think this issue is related to the route. Any ideas???