Railworks America

Hi All:

I have run into an issue that is probably just in my setup but I am at odds as what to do.

Problem:
After I have selected a certain number of providers/products (Say 50) in the list all is okay, but when I check one more additional provider/asset I get the "SBHH".
If I remove one provider/product and recheck the box that had previously caused the SBHH it works, but I can not check any other boxes.

I have noticed that some of the other routes have well over 100 providers/product shecked and I am lucky to get half that number.

It seems to be some sort of memory issue but I have 8gigs mem and my HD is no way near full about 200gigs out of one tera.

Any ideas/suggestions would be greatly appreciated.

I would guess that it's two different models clashing with one another, somehow.

That's a odd one alright. Try examining your RouteProperties.xml before and after that "trip point" for any anamolies. Or, does this same thing happen in every route?

It happens on a couple of different routes that I have. One is just a test route for some AI traffic test, Using mostly default equipment. Actually the AI test route is using the default route parameters.
I have about 20 assets checked on that route. But when I try fot say a hundred assets it crashes.

Update on this. I tried adding a lot of assets to the Test Trak program with the same results SBHH. Restored to original two assets and all is fine.

More testing on my part has found that the problem is somewhere in my KUJU RailsimulatorUS files. I can check all the boxes except the KUJU RailsimulatorUS box and have no problems.

I have found that with KUJU RSUS checked these programs cause SBHH. IHH-USRailroads, JCornell-EMD, JL-TP, JL-Scenery, JL-RailSimulatorUS, John-Lippai-Williamette and NS Newriver Districts, Josef72-Addon. All of the assets ahead of IHH in my asset list do not cause any problems.

That's as far as I have gone I am sure there are many more, I just haven't gone through all of them yet.
It seems to me there is something fowled up in my RailSimulatorUS files but I have no idea what it is or where it is.

I am pretty sure this is a unique problem with my system.

How do you read the .dmp files. I have tried using the LogMate but that is coming up witth a blank page.