How Many Assets

[sleepyto]

Hi All:

I have run into an issue that is probably just in my setup but I am at odds as what to do.

Problem:
After I have selected a certain number of providers/products (Say 50) in the list all is okay, but when I check one more additional provider/asset I get the "SBHH".
If I remove one provider/product and recheck the box that had previously caused the SBHH it works, but I can not check any other boxes.

I have noticed that some of the other routes have well over 100 providers/product shecked and I am lucky to get half that number.

It seems to be some sort of memory issue but I have 8gigs mem and my HD is no way near full about 200gigs out of one tera.

Any ideas/suggestions would be greatly appreciated.

[Trainguy76]

I would guess that it's two different models clashing with one another, somehow.

[Toripony]

That's a odd one alright. Try examining your RouteProperties.xml before and after that "trip point" for any anamolies. Or, does this same thing happen in every route?

[sleepyto]

It happens on a couple of different routes that I have. One is just a test route for some AI traffic test, Using mostly default equipment. Actually the AI test route is using the default route parameters.
I have about 20 assets checked on that route. But when I try fot say a hundred assets it crashes.

[sleepyto]

Update on this. I tried adding a lot of assets to the Test Trak program with the same results SBHH. Restored to original two assets and all is fine.

[sleepyto]

More testing on my part has found that the problem is somewhere in my KUJU RailsimulatorUS files. I can check all the boxes except the KUJU RailsimulatorUS box and have no problems.

I have found that with KUJU RSUS checked these programs cause SBHH. IHH-USRailroads, JCornell-EMD, JL-TP, JL-Scenery, JL-RailSimulatorUS, John-Lippai-Williamette and NS Newriver Districts, Josef72-Addon. All of the assets ahead of IHH in my asset list do not cause any problems.

That's as far as I have gone I am sure there are many more, I just haven't gone through all of them yet.
It seems to me there is something fowled up in my RailSimulatorUS files but I have no idea what it is or where it is.

I am pretty sure this is a unique problem with my system.

How do you read the .dmp files. I have tried using the LogMate but that is coming up witth a blank page.