Railworks America

[/center]A small...very small problem.s ....with them

Someone has a solution to fix that please....thanks

Think you have to install the other version, too.

Did you do all this? It's a bit confusing.
4- To allow the repaints showing up in the scenario editor make a copy of the CabView_HighShortHood folder and paste it at the same location.
Rename it CabView_DMIR, inside open the file SD40-2_SOU_HH_Cab.GeoPcDx with TS-Tools. Click on Search and Replace, write engine in the top window and DMIR in the lower one.
Then click on Find, click on Replace three times, save it and that's it.
5- Do the same for the three other DMIR units.

Except that,,,everything work perfect...just when you re inside the cab that you can see that...sorry

thanks

If you need some help getting all that done let me know and I'll help you out.

For me and for all others ....please how can you fix that....thanks

At this point I'm confused also.

OK here is a fix. The bin file needs to be changed in EACH locomotive.
This line needs to be changed from this:

<InteriorGeometryID d:type="cDeltaString">HIS\SOURetroPack01\RailVehicles\Diesel\SD40-2\CabView_DMIR\[00]SD40-2_SOU_HH_Cab</InteriorGeometryID>
to this:

<InteriorGeometryID d:type="cDeltaString">HIS\SOURetroPack01\RailVehicles\Diesel\SD40-2\CabView_HighShortHood\[00]SD40-2_DMIR_HH_Cab</InteriorGeometryID>

I have included the new GEO for the CabView. It needs to just go into the CabView_HighShortHood folder. No need for the additional CabView folder. This one should work for all versions.

Thanks for all...

Work perfect now....thanks again

The faulty file will be replaced soon in the file library. I still wonder why I don't have this problem with my repaint. Thanks anyway Buzz

I would like to know if everyone who downloaded my repaint experienced the same problem as Nykolas because, I repeat, I don't have this problem in my case with the basic configurations in the Bin files.

I might have gotten confused by the instructions.