by buzz456 » Thu Sep 11, 2025 1:04 pm
Did you do all this? It's a bit confusing.
4- To allow the repaints showing up in the scenario editor make a copy of the CabView_HighShortHood folder and paste it at the same location.
Rename it CabView_DMIR, inside open the file SD40-2_SOU_HH_Cab.GeoPcDx with TS-Tools. Click on Search and Replace, write engine in the top window and DMIR in the lower one.
Then click on Find, click on Replace three times, save it and that's it.
5- Do the same for the three other DMIR units.
Buzz
39 and holding.
"Some people find fault like there's a reward for it."- Zig Ziglar
"If you can dream it you can do it."- Walt Disney
