Railworks America

I know the Searchlight GEVO-12 is no longer supported but I wanted to see if there's a fix.
This only applies to the CP ES44AC from the Canadian Mountain pass route.
The issue is the non advanced brakes version has its ditch lights and cablight are on and the RPM is stuck at 1-2. Meanwhile the regular version works but when I try to apply the breaks the key short cut does not work. You got to do it via the UI.

Is there a fix for it?

If you are talking about the GEVO Enhancement by Searchlight Simulation, the best you can do to reestablish an old DLC, is installing the GEVO again over all older supported DLC.
But I am not sure. But if I remember well, there was an issue with advanced brakes which were not supported.

jalsina wrote:If you are talking about the GEVO Enhancement by Searchlight Simulation, the best you can do to reestablish an old DLC, is installing the GEVO again over all older supported DLC.
But I am not sure. But if I remember well, there was an issue with advanced brakes which were not supported.

I did reinstall it and well, that causes it to be broken I'll try again though.

Update it didnot work