RWA Route Freezing Up?

[gtw5812]

Hello Folks,

I am currently running on a new install of Train Sim and I have re-installed RWA. I created a free roam scenario and when I go to run it, everything loads fine. I select an engine and when I go to select a switch stand with a the mouse, the whole game freezes. The only way to get out of it is "Control/Alt/Delete" Task manager will not even work. I have tested this in multiple routes with multiple engines, and it only does it in RWA and when manually trying to use the switch stand? Any ideas?

Thanks,

Galen

[buzz456]

So am I correct that if you use the g key it works OK? The other question I have is are you on the public beta or not? I can't replicate it here btw.

[Cardinal51]

G Key ???

[buzz456]

Task Controls

Tab, Ctrl+Tab - Ask for permission to pass red signal ahead/behind

G, Shift+G - Change switch ahead/behind

Ctrl+Shift+C - Couple/uncouple rolling stock
T, Shift+T - Open doors/Load/Unload/Refuel (depends on your train and position)
Ctrl+-, Ctrl+= - Change cab