Railworks America

Hello Folks,

I am currently running on a new install of Train Sim and I have re-installed RWA. I created a free roam scenario and when I go to run it, everything loads fine. I select an engine and when I go to select a switch stand with a the mouse, the whole game freezes. The only way to get out of it is "Control/Alt/Delete" Task manager will not even work. I have tested this in multiple routes with multiple engines, and it only does it in RWA and when manually trying to use the switch stand? Any ideas?

Thanks,

Galen

So am I correct that if you use the g key it works OK? The other question I have is are you on the public beta or not? I can't replicate it here btw.

G Key ???

Task Controls

Tab, Ctrl+Tab - Ask for permission to pass red signal ahead/behind

G, Shift+G - Change switch ahead/behind

Ctrl+Shift+C - Couple/uncouple rolling stock
T, Shift+T - Open doors/Load/Unload/Refuel (depends on your train and position)
Ctrl+-, Ctrl+= - Change cab