Installing a reskin issue
First unread post • 3 posts
• Page 1 of 1
Installing a reskin issue
by AmericanSteam » Sat Dec 23, 2023 6:54 pm
I wish to install the CN F3 driver and non driver livery from the RWA file library to the DTM F3 pack. Dropping the files into the DTM/F3 folder is pretty much straight forward but the instructions call for using TS_Tools to change some .geo files and rename them. I have been at this for a few hours now without success. I can only get the couplers to show when placed. Can someone who has the DTM F3, package this up for me or offer some help through PM? Instruction #4 is a bit unclear.
Just an old Alaska guy trying to live in an insane world. Degree in life, Masters in common sense.
-
AmericanSteam - Posts: 2869
- Joined: Mon Nov 02, 2015 9:54 am
- Location: Nikiski, Alaska
Re: Installing a reskin issue
by buzz456 » Sun Dec 24, 2023 8:01 am
Check your PM.
Buzz
39 and holding.
"Some people find fault like there's a reward for it."- Zig Ziglar
"If you can dream it you can do it."- Walt Disney
39 and holding.
"Some people find fault like there's a reward for it."- Zig Ziglar
"If you can dream it you can do it."- Walt Disney
-
buzz456 - Site Admin
- Posts: 21056
- Joined: Sun Mar 21, 2010 8:30 am
- Location: SW Florida
Re: Installing a reskin issue
by AmericanSteam » Sun Dec 24, 2023 1:59 pm
This was interesting, I am not used to putting files within the AP. Most all of my other reskins everything has been outside the .ap file. That was my issue. I should be able to do the other version.
Thank you Buzz.
Thank you Buzz.
Just an old Alaska guy trying to live in an insane world. Degree in life, Masters in common sense.
-
AmericanSteam - Posts: 2869
- Joined: Mon Nov 02, 2015 9:54 am
- Location: Nikiski, Alaska
3 posts
• Page 1 of 1
Return to Problems and Peculiarities
Who is online
Users browsing this forum: No registered users and 1 guest