Page 1 of 1
Photoshop problem
Posted:
Wed Jan 18, 2023 10:28 pmby slick204
So everything was working fine before lunch then when I got back to working on a repaint, Photoshop (CS2) will no longer save as an ACE or DDS file. It says it cannot save because of a program error. Everything else is working, as far as I can tell.
I have reinstalled the ACE and DDS plug-ins, repaired photoshop, removed and reinstalled photoshop to no avail.
I know this is a long shot but does any one have any ideas? Thanks.
Re: Photoshop problem
Posted:
Thu Jan 19, 2023 6:09 amby mindenjohn
I had similar and it was my anti-virus putting Photshop into containment. I switched off the auto-containment and back to normal after a complete restart.
Re: Photoshop problem
Posted:
Thu Jan 19, 2023 11:43 amby slick204
Were you still able to use photoshop? Everything else works except saving as an ACE or DDS file.
I'll try turning auto-containment off, if it has it. Thanks!
Re: Photoshop problem
Posted:
Thu Jan 19, 2023 12:04 pmby harryadkins
I Use RS-Bin and DXTBMP to get around that issue. Works great.
Harry
Re: Photoshop problem
Posted:
Fri Jan 20, 2023 2:49 pmby slick204
I used that method yesterday Harry. It seems clunky to me but I suppose I'll get used to it eventually.
I tried Gimp as it has built in DDS support, however it doesn't ask how many mipmaps you want. I assume that's a problem!
Re: Photoshop problem
Posted:
Fri Jan 20, 2023 4:47 pmby slick204
I finally figured it out. It occurred to me that this started after I saved a selection in the .psd file. I noticed that it showed up in the channels tab, just below the alpha channel. I just deleted it and now I can save again.
I'll leave this here in case anyone else has this issue.