Railworks America

Was wondering if anyone else got these from here:

https://www.mersel.nl/ts2014-weathering-the-cp-es44ac/

For some reason when I install them, they dont show up??? Any idea on how to fix this???

Did you unpack the ap as instructed?

Yup...Did this here....Then navigate to: ..\Railworks\Assets\PMdesign\JL_CPES44AC\ and run CPES44AC_Install.bat.

And nothing...Does it work for you???

WCL6655 wrote:Yup...Did this here....Then navigate to: ..\Railworks\Assets\PMdesign\JL_CPES44AC\ and run CPES44AC_Install.bat.

And nothing...Does it work for you???

No, don't have the CP ES44AC. Does the download come with a folder containing the assets?

Sadly no

I just downloaded and installed following Paul's instructions. I opened up a free roam scenario for Canadian Mountain Passes, activated JL\CP and placed the 3 locos alongside the default. I Have no idea why it didn't work for you.




EDIT: Oh look, I put 2 locos in the same space. CRASH!

See I did the same....I checked them in the flyout option and then they show up in the loco selection area, but when I try and place them, there is no loco when I move it to the map

Are they in the folder when you go look? Did you copy the Geo's over?

What Gevos need to be copied?

Install the .rwp file using utilities.exe located in your Railworks Main Folder.
Then navigate to: ..\Railworks\Assets\PMdesign\JL_CPES44AC\ and run CPES44AC_Install.bat.
This installer will copy DTG files from the default folder into your repaint folders.
This should complete the install. All 3 repaints should now be available to you.

Try running the install bat again and at the very end it will ask if you want to overwrite 3 times. Say Y to all 3.

When I run it....I get this

The batch file seems to not find a lot of files. That seems to indicate that EITHER the files are in the wrong place OR the bat file is looking in the wrong place.

Specifically, the bat file is not finding the necessary GeoPCDX files that are needed for the locos to be visible. (Those are the Geos that Buzz referred to.)

It occurs to me that it is possible the CMP assets file are in an AP file and can't be read by the bat. Check in Assets/JL/CP and be sure the files have been extracted from the CanadianPacificAssets.AP. At least the rail vehicles folder. Then run the bat file again. Say yes to ALL overwrites.

I wonder cause I installed TS in another spot E:\Games\SteamApps\common\RailWorks

The install me thing is in this folder here