Page 1 of 1
Red & Blue NW EMD GP9 - No Controls

Posted:
Wed Jul 13, 2016 6:21 pm
by mysterytrain
I downloaded and installed both the Red and Blue Norfolk Western EMD GP9 repaints from the file directory.
Only thing is, there's not a control / throttle for either engine when I try to run them!
Any idea on what is causing this and what can I do to fix it?
BTW, I deleted all files and re-installed, still no change.
Re: Red & Blue NW EMD GP9 - No Controls

Posted:
Wed Jul 13, 2016 7:06 pm
by trev123
I presume you have this. Michael Stephan’s EMD Boston & Maine GP9 as mentioned in the instructions.
Re: Red & Blue NW EMD GP9 - No Controls

Posted:
Wed Jul 13, 2016 7:10 pm
by mysterytrain
Yes, I downloaded and installed this file first. However, I just went back and checked the BM engines that come in this pack, and no operating controls appear for them either!
Yikes!

Re: Red & Blue NW EMD GP9 - No Controls

Posted:
Thu Jul 14, 2016 2:43 pm
by GreatNortherner
Hello,
My guess, without currently being able to check it in-game, is that you are not running the game in Expert mode. I'm fairly sure that all of my loco models lack the controller setups for Intermediate and Simple Controls.
Michael
Re: Red & Blue NW EMD GP9 - No Controls

Posted:
Fri Jul 29, 2016 8:47 pm
by mysterytrain
GreatNortherner wrote:Hello,
My guess, without currently being able to check it in-game, is that you are not running the game in Expert mode. I'm fairly sure that all of my loco models lack the controller setups for Intermediate and Simple Controls.
Michael
That was it Michael. I switched over to the Expert Controls and everything works fine!
Thanks for the help.
*Issue Resolved*