Railworks America

I'm having a problem trying to load up this repainted Genset. All I get are couplers showing up.
Has anyone got this engine working?
I think I'm following the loading instructions although this is a new method for me.
I sure like the RWP system the best. It works best for us mere mortals.

Any help will be appreciated,
Thanks,
Bob

90+ % of the time if all you are getting is couplers it is a result of the GeoPcDx file being in the wrong place. Make sure it is in the engine folder for your re-paint.

Hi Buzz 456
Thanks for the info. I do have the GeoPcDx file in the engine folder and just did the whole procedure over again and I have the same results.
Just a lot of couplers.
I even did a cache cleanup and that did not work.
Maybe I'll delete the whole repaint folder and start all over again. Maybe I'll get lucky.
It takes me a lot of tries before I get it right:)

Thanks again Buzz

Your setup should look like this. Look at the path on the top to make sure you are in the right place. The GeoPcDx from the 'Engine' folder needs to go into the EngineRSSX.

Thanks Buzz that was my problem. I did not have the RSSX Engine folder in the right spot and had a problem getting the GeoPcDx file to install in the new folder. Now I have these new engines all over my route
Was well the effort to get it running.

Thanks so much for the help.
Bob