Railworks America

I could not find the original default sd40t-2 can someone help me install a repiant

http://s1.zetaboards.com/DigiRails_Foru ... 3765220/1/

do you have donner Pass?

Yes I do

Well you asked about the default SD40T-2 and it's not a default.

I but it asks fot the default sd40t-2s geopdxfile which I cannot find

It's in here:

\Assets\RSC\DonnerPass\RailVehicles\Diesel\SD40T-2\Default\Engine

Depending on how long ago you got your Donner Pass DLC, you may have to use 7zip to extract the .ap file for the route. It sounds harder than it is.

When I go in sd40t-2 folder only one is SP 8802

Maybe because that's the one you downloaded.

yes but they ask for a file from the original sd40t-2

shadesman89 wrote:yes but they ask for a file from the original sd40t-2

Please read the posts of people trying to help you. The 8802 is the new one that you installed. You need to get the Geo from the Donner SD40T which you may need to unpack from the .ap file and then put it into the 8802.

Depending on when the OP and reskinner got into Train Simulator, the Donner Pass SD40T-2 might in fact be a "default" engine.
For most of us, the Cajon Pass SD40 are what we consider "default" but if they got in when Donner became a base route in TS, then that would seem like default to them.

For future reference noobies, the Cajon Pass stock is what we refer to as "Default U.S. Stock" Those engines and cars also come with the U.S. Loco and Asset Pack at Steam.
Found here. It's better to just buy Cajon Pass though, because you get a route to drive, and it's frequently on sale, cheaper than the Asset Pack.
http://store.steampowered.com/app/20830 ... _151_150_1

Eric I think if you look at the Donner SP SD40T folder, the identity of the Geo file is Default because that's the SP loco for Donner.

How do I unpack the ap file exactly?

May I have a at step by step tutorial maybe?

Do you have winzip or 7 zip on your computer?