Centipede Alpha Bug.

[ErikGorbiHamilton]

http://steamcommunity.com/sharedfiles/f ... =277471435


Its not mine but a friends centipede. The trucks wont show up. if I'm correct isn't this a alpha Bug (the MSTS bug where the trucks wouldn't load)? I need some instruction so i can relay to him.

Thanks, BNOV2~

~E Oops, the image wont show up. Anyways the its just a picture of the centipede with the trucks missing.

[fraserm]

http://steamcommunity.com/sharedfiles/filedetails/?id=277471435


Its not mine but a friends centipede. The trucks wont show up. if I'm correct isn't this a alpha Bug (the MSTS bug where the trucks wouldn't load)? I need some instruction so i can relay to him.

Thanks, BNOV2~

~E Oops, the image wont show up. Anyways the its just a picture of the centipede with the trucks missing.

The Centipede is a three-part locomotive in TS2014. The body is found in the locomotive section, but the trucks are found in the rolling stock section. You must first place the body, then the front truck, then the rear truck, then finally you need to reverse the rear truck for the loco to operate properly. Then you can select the entire assembly with <shift> left-click to move it to the correct position. All this is detailed in the manual for the loco provided in the manuals section of the TS2014 Utilities app.
Hope this helps.
Best,
Marc

[ErikGorbiHamilton]

http://steamcommunity.com/sharedfiles/filedetails/?id=277471435


Its not mine but a friends centipede. The trucks wont show up. if I'm correct isn't this a alpha Bug (the MSTS bug where the trucks wouldn't load)? I need some instruction so i can relay to him.

Thanks, BNOV2~

~E Oops, the image wont show up. Anyways the its just a picture of the centipede with the trucks missing.

The Centipede is a three-part locomotive in TS2014. The body is found in the locomotive section, but the trucks are found in the rolling stock section. You must first place the body, then the front truck, then the rear truck, then finally you need to reverse the rear truck for the loco to operate properly. Then you can select the entire assembly with <shift> left-click to move it to the correct position. All this is detailed in the manual for the loco provided in the manuals section of the TS2014 Utilities app.
Hope this helps.
Best,
Marc

The trucks come in as rolling stock? Wow! I would have never guessed that! I will relay this message to my friend.
Thanks! BNOV2~

[Ericmopar]

The Challenger is the same way. I can't understand why the loco sections are separated that way. If you look at Dick's Steam engines, the loco and tender are both in the engine section.