GP60 pack 1 horn and bell missing...

[wongsing]

Has anyone had any problems with the sound on these locos (BNSF GP60M and GP60 NS) not working properly? I cannot seem to figure out why my horn and bell will not work. When talking to Ian Allen (purchased from his site) he tried to help and he is stumped too. He did mention that I had to unpack the Kuju ap. asset files because they utilize the sounds from it. After doing that, I noticed the engine, compressor, traction motor sounds, etc. all started working but no bell or horn.

Any ideas?

-Richard Wongsing

[wisrailfan]

I've had the same problem with those. Tried uninstall and reinstall on several occasions. Re-downloaded the files twice and overwrote and then did a reinstall with no effect. This one's a mystery to me.

[wongsing]

I finally figured this out!

For anyone that is interested (if there is anyone having the same problem with their GP60's from pack 1) just ask, as it could get pretty involved in explanation. However, I can say that the lines in the proxyxml file referencing the horn point to some sound files that are no longer present in Railworks 2014...Atleast in my install. Had to find out which proxyxml file belonged to which loco in this case, the GP60 in question. I then changed the lines in the proxy file and added some horn wav. files to the default SD40.

Again, I can explain it better if anyone needs it but I will refrain from typing it all up unless someone needs help.

-Richard