Page 1 of 1

Miffed at PLE signals - help

Unread postPosted: Wed Jan 01, 2014 6:18 pm
by HankySpanky
I know this has been hashed and re-hashed, and I have read and done everything I can find on the missing signals issue on the PLE and Connersville routes downloaded from Otto's site. The signal posts are there but no light head.

Here is where I'm at -

Detail level set to 10

1) Originally ran RWTools route check and saw missing assets (ie: Assets\Kuju\RailSimulatorUS\railnetwork\signals\us modern\post\smm_uss_ns_g2 h2 t2.bin...etc.).

2) Located and c/p missing assets from RCAP v2 to Assets\Kuju\RailSimulatorUS\railnetwork\signals\us modern\post\.

3) Ran RWTools again and confirmed that the assets were no longer missing.

4) Cleared cache.

5) Ran PLE free roam scenario - Still no signals!

6) Reinstalled PLE - Still no signals!

7) Rebooted PC - Still no signals!

8) Checked Kuju boxes on developer flyout - Still no signals!

9) Promised God that I would be a better person - Still no signals!

I give up!!! What am I doing wrong???????????? !*hp*!
!*whack*! !!jabber!! !*snd-help*!

Re: Miffed at PLE signals - help

Unread postPosted: Wed Jan 01, 2014 8:37 pm
by JohnTrainHead
Do you have the old SMM Digital signals? Jessie has them uploaded on Digirails.

Re: Miffed at PLE signals - help

Unread postPosted: Wed Jan 01, 2014 10:45 pm
by HankySpanky
Hey John,

I had read earlier another post of yours on another thread about Digirails having the file but I thought someone wrote that RCAP v2 had the same thing, but it didn't work.

So I took your advice and dug a little deeper and registered at Digirails and got the download link. It WORKS but - I loaded 4 files in order to get it to work. I will post the link and the files in a separate post (below), just in case Bob has to delete it for some EULA issue. Or maybe Bob can put it in the file library. Either way, I hope it saves some poor sucker from having to go through what I had to. Zoinks!

Thanks much for your help! !*YAAA*!

Re: Miffed at PLE signals - help

Unread postPosted: Wed Jan 01, 2014 10:58 pm
by HankySpanky
Here are files to repair missing signals on the P&LE and Connellsville routes:

Credit for these files goes to jessiejames2 from Digi-rails. www.http://s1.zetaboards.com/DigiRails_Forums/index/

Download: http://www.mediafire.com/?7y6t1dmz41in1ht

Load rwp files: SMM_USSSignal_NS.rwp
SMM_USSSignal_Shapes1.rwp
SMM_USSSignal_Shapes2.rwp
SMM_USSSignal_USDef2.rwp