Otto/Thomas Cajon Route Final

[LandN]

I started out running the Mitsubishi Cement scenario. It ran fine until I got almost to Lugo and it froze up. Will not resume at the last save point.

Ran the route thru RW Tools and came up with several missing items. The largest one seemed to be 3D Scale Rails. I thought I had all of them. Can someone tell me which one is used in this route?

Also had some files from All Aboard\Track Plans that were missing and some from RSC\Brighton Main Line

Any help in obtaining these missing files would be appreciated.

Jay

[BlueLight]

The Putnam-bsb-mojave-trona-final is the route that you should be using to run that scenario.
You can find the route at [url]www.otto-wipfel.co.uk/rw-downloads][/url]

[LandN]

That is the one I am using. Just couldn't think of the full name. I have run both of your Trona scenarios with no problems.

[BlueLight]

If you have any of these routes then you will have Track Plans,
Colton & Northern
Fort Kent to Eagle Lake
Fort Smith to Heavner
Ohio Steel 2
Rascal & Cottonwood
Hope this helps.

[LandN]

OK, but I still need to know which version of Scale Rails I need. I thought I had all of them.

Jay

[BlueLight]

If haven't done so already you need to have all three freeware versions stored on your hard drive.

[LandN]

I thought I had all three of them, but obviously I missed something.

[BlueLight]

I had to re-download all them once myself. It wouldn't hurt.

[LandN]

Well, that didn't work. I installed/reinstalled all of the missing assets. Reran the scenario. Worked fine until I got within 2.25 miles of Lugo and it froze up again. Same place as last time.

Jay