Loads Not showing?

[gkbaldwin]

Hi again;

On to a new item. Going through and loading different cars from Portland Terminal Route. In this case the 50FT flatcars. I am getting two of the four loads to show and two do not. The loads are I-Beam and Steel, which do not show up (this is true for both B&M and MEC). Logs and rails do show up. I have gone through to check for file misspellings or folders not pointing to the right file and all looks okay to me.

Portland Terminal was upgraded to TS2013...right.

I am running a high-end system with dual Nvidia 580's and all Railworks options set to high.

Any suggestions on what to check or why this would be happening would be appreciated.

Regards, Gerry

[gkbaldwin]

I did a clean reinstallation and this seemed to resolve my issues. I am not sure what got corrupted or when, but it seems that this is happening a lot to Railworks.

Regards, Gerry