Its a bird,its a plane....

[RAILSOHIO]

Since the latest update I have sections of track,all switches,floating high in the sky. Both in the new route I am building,and in Test Trak. I can NOT select the track to delete it. I can not connect new track to it to delete both,either. These are random sections of track,not ones that were on the ground and now in the air. Any Ideas?

[barnez]

there may be a better way but:

the last time I encountered this issue I had to select the ground with a click+hold to get a selection circle, the track in question got selected (along with everything else in the radius) and I was able to delete the flying track.

Of course, there was a bit of collateral damage to replace also

-barnez

[RAILSOHIO]

Well I just tried that. It will delete objects on the ground but not in the sky. Jerry's Atlanta route has the same problem,I just found out. The built in routes I checked do not have this problem. It seem you really do have to back up content before a new update. But with steam updating automatically ,that can be hard to do. I had 26 bad files,and had to do a "verify game cache" after last nights update.

[RAILSOHIO]

Here's an update. The "rails in the sky" do not show in driver. Thats great,but it still bothers me.,that they are there in the editor mode.

[barnez]

odd that it will not snag them - select radius on the ground is supposed to grab everything (unless this has changed in RW3 too )

only other thing I can say there is try to go directly overhead of the malicious track so you can better judge where in 3D-space-land it is really hovering ... maybe your selection isn't grabbing the pesky ribbon

if all else fails:



-barnez

[robbit]

clear your cache and they should go away without having to delete anything

[RAILSOHIO]

Well they are gone. Clearing the cache is a good suggestion,but I do it each time I start RW. I hope to not see these "flying Switches",again, lol!