EMD SD40-2 DMIR

[jtousign]

If I understand correctly, I don't need to make any changes to my repaint in the file library?

[drjayyyy]

I can only get the first one to work.

[buzz456]

I can only get the first one to work.

I'm not following. You mean show up at all or the cab issue?

[drjayyyy]

Out of the four the only one that I can run in the sim is DMIR.The first one. It displays fine. Runs fine.The cabview is fine. The remaining 3 I made the required changes to all bin files but nothing.

[buzz456]

Did you make sure and put the line like this? Usually when they don't show up at all it's because this line is goofed up.


<InteriorGeometryID d:type="cDeltaString">HIS\SOURetroPack01\RailVehicles\Diesel\SD40-2\CabView_HighShortHood\[00]SD40-2_DMIR_HH_Cab</InteriorGeometryID>

[drjayyyy]

Hey Buzz.Something I realiized. This line is missing from DMIR 2-3-4 bin files.<InteriorGeometryID d:type="cDeltaString">HIS\SOURetroPack01\RailVehicles\Diesel\SD40-2\CabView_DMIR\[00]SD40-2_SOU_HH_Cab</InteriorGeometryID>. When I click find in TS tools. This does not appear.

[buzz456]

Jean already changed it to something else. Try just searching for InteriorGeometryID and see what shows up.

[drjayyyy]

InteriorGeometryID Does appear. I tried copying the DMIR bin which works and renaming it to DMIR2 and renaming and all text to DMIR2. No change. I'm missing something.

[buzz456]

If you insert what I suggested it should work and no need to do a 2 etc. the dmir should work for all versions since you can't see the numbers from inside the cab.

[drjayyyy]

Got it. Thanks