Railworks America

In the attachment I would like to make a 90 degree elbow with the ability to have it snap to a end of pipe or start a lofted pipe from either end.



I know its possible I just don't know how. I have the a lofted pipe that starts with a 90 degree elbow, but I would like to have the ability to spot a elbow and then start
placing lofted pipe from either end.

Any Ideas will be greatly appreciated.

Thanks in Advance
John

This can only be done is the joint is defined as a network item, such as a roadway intersection.

Thanks for the reply.

Is there anything special that has to be done when setting up one of these network items?

John