RW GN Freight Scenario for Pike's Eagle Ridge Bay 1.2

A Great Northern Scenario for Pike's Eagle Ridge Bay route: Your job is to assemble a long train of loaded grain hoppers and take them to the next big yard. There are two pick-ups along the way. Quite difficult due to the weight of your train.
The scenario uses two payware downloads, some freeware and some default rolling stock.
By Michael Stephan

To run this scenario you must have installed the route "Railworks Pikes Eagle Ridge Pack", version 1.2.
You can get it at trainsim.com: http://www.trainsim.com/kdl.php?fid=24563

The scenario will guide you through your job with a number of pop up messages for your work orders.
Please note that on this particular route you MUST set all switches on your own! So always zoom around on the 2d-map well in advance so you won't run into a closed switch.
There will also be a few occasions where a signal ahead of you might be red in spite of the line being all clear. But in these cases you should be able to pass when asking for permission (TAB key).
Also note that there is a lot of AI traffic and you must always stay on the right-hand mainline except for the second pick up, where you will cross over the left-hand main briefly to access the yard.

Below is a list of the rolling stock required by this scenario.

Required Payware Add-ons
========================

Dick Cowen:
~~~~~~~~~~~
GN Freight Packs 1 and 2
http://dickyjim.com/special.html

Required Freeware Add-ons
=========================

GN 40' flatcars
~~~~~~~~~~~~~~~
http://golden-age-rails.com/flat.html
-- or alternatively: http://trainsim.com/kdl.php?fid=22410

GN Caboose Reskins
~~~~~~~~~~~~~~~~~~~~~~~~~~~
on trainsim.com
cab_gn.zip
or http://railworksamerica.com/fl/rl-st.html

F7 Reskins (Cesar E. Pach's models)
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
on trainsim.com
gn_f7ab3.zip
gn_f7ab2.zip
gn_f7ab1.zip

also require installation of ATSF base model:
http://www.argensim.com.ar/?cat=22

40' boxcar reskins
~~~~~~~~~~~~~~~~~~
all on trainsim.com:
np_boxes.zip
gn_boxes.zip
box_np-1.zip
cbq_box.zip
sps_box-1.zip
box_prr.zip
box_sf.zip

GN SW900 Reskin
~~~~~~~~~~~~~~~~~~
gnsw9.zip on trainsim.com http://www.trainsim.com/kdl.php?fid=22835
or http://www.elvastower.com/forums/index.php?app=downloads&showcat=55

Also needed for engine: installation of SW1200 Re-Skinning kit

brtkit05.zip and swcabug1.zip on trainsim.com
or http://railworksamerica.com/fl/rl-st.html

PS2-Hopper Reskins
~~~~~~~~~~~~~~~~~~
on trainsim.com:
ps2-gn.zip http://www.trainsim.com/kdl.php?fid=25038
ps2-milw.zip http://www.trainsim.com/kdl.php?fid=25039
ps2-np.zip http://www.trainsim.com/kdl.php?fid=25040
ps2-cbq.zip http://www.trainsim.com/kdl.php?fid=25033

OR also available at
http://railworksamerica.com/fl/rl-st.html or
http://www.elvastower.com

HS Hopper Reskins
~~~~~~~~~~~~~~~~~
lo-hs-gn.zip on trainsim.com
http://www.trainsim.com/kdl.php?fid=25063

OR also available at
http://railworksamerica.com/fl/rl-st.html or
http://www.elvastower.com

Defaut Hopper Reskins
~~~~~~~~~~~~~~~~~~~~~
lo-3b-gn.zip on trainsim.com
http://www.trainsim.com/kdl.php?fid=25059

OR also available at
http://railworksamerica.com/fl/rl-st.html or
http://www.elvastower.com

Disclaimer:
===========

Although it is unlikely to happen at all, I shall not be held responsible for any damage any part of this archive might do to your system. You agree to use the files on your own risk.

Michael Stephan
www.golden-age-rails.com

support@golden-age-rails.com
RailWorksAmerica and trainsim.com: GreatNortherner