EJE Baldwin DR-4-4-1500 Pack

This is a repaint of DTM's 'TS Marketplace: New York Central RF-16 Livery Add-On' as the Elgin, Joliet and Eastern (EJE) Baldwin DR-4-4-1500 'Sharknose' (Road Numbers 700 and 701, units A and B).
In addition, also there are repaints of some 40ft Boxcars and Cabooses in EJE liveries. Preloaded consists are included, these will appear at Quick drive menu in 'Baldwin DR-4-4-15' block.

History:
The Baldwin DR-4-4-1500 demonstrator was sold to the EJE on December 22, 1950 under a lease-purchase agreement, the cabs units were renumbered 700A and 701A, and the boosters were 700B and 701B.
These engines did not work out well on the EJE, and units were transferred to the Duluth, Missabe and Iron Range Railway (DMIR). On the DMIR only two units A and B were found operable, and were renumbered 728-729, but not repainted from the EJ&E orange and green.
At the end of the EJE's agreement in 1955, all four units were sold to the 'Baltimore and Ohio'.

Requirements:
You need have installed the DTM New York Central RF-16 Livery Add-On from Steam.
About Boxcars, they are based on Michael Stephan’s freeware 40ft PS1 Boxcar (available at 'http://www.stephan-michael.de/railsim/packsrw/box40ps1.html' and at 'www.golden-age-rails.com/packsrw/box40ps1.html') and you need to have installed to use Audio and Couplers files.
Cabooses need RSC's 'Southern Pacific Cab Forward Loco Add-On' from Steam.


Install:
1) Unzipp downloaded file and copy Assets folder into Railworks main folder.
2) Copy files 'Baldwin_RF16.GeoPcDx' and 'Baldwin_RF16_B.GeoPcDx', from DTM\Baldwin RF-16-NYC\RailVehicles\Engine folder and paste them in new DTM\Baldwin RF-15-EJE\RailVehicles\Engine folder.
3) Copy file 'Baldwin_RF16_NYC_lightningl.GeoPcDx' from DTM\Baldwin RF-16-NYC\RailVehicles\EngineLightningStripe folder and paste it in new DTM\Baldwin RF-15-EJE\RailVehicles\EngineLightningStripe folder
3) Copy file 'RF16_Cab_Cigar.GeoPcDx' from DTM\Baldwin RF-16-NYC\RailVehicles\Cabview folder and paste it in new DTM\Baldwin RF-15-EJE\RailVehicles\Cabview folder
4) Copy file 'C-40-3_SP1.GeoPcDx' from RSC\CabForwardPack01\RailVehicles\Freight\Caboose-C-40\Default\ folder and paste it in new EJE-504 and EJE-529 folders.
5) Copy file 'C-40-3_interior.GeoPcDx' from RSC\CabForwardPack01\RailVehicles\Freight\Caboose-C-40\Default\PassengerView folder and paste it in new EJE-504\PassengerView and EJE-529\PassengerView folders.

Don't forget to copy your own '_.sbn' and '_.sbn.MD5' files from  RF-16-NYC main folder to the new RF-15-EJE; without them it will not work.

Enjoy it